Subscribe to download
Rookie SaR

*edit - not working as a starter classic carreer since i dont know wich update, i will get back to it when i have time*

A boat to get you started on a brand new Classic Carreer game !
*note : upon starting the game you are given 5 research points, chose Sensors (4 points) and Navigation ( 1 point ), sleep it off and start playing. You can use the boat right away but you wont know your speed or your heading( will barely impact the boat )*


The Rookie is a fast coastal SaR boat with limited fire fighting capability. It could be used as a RHIB also, as it is quite compact and light. As a total starter boat, it is devoid of screens and advanced navigation aparatus.

Specs :
cheap ! 9715 $ and you're set !
Size Lxlxh : 38x11x11 blocs, 5 blocks to the waterline (9.5x2.75x2.75m, 1.25waterline)
Weight : 1434 whatever the SW weight is
Fuel : 1115 L refillable
Electric Anchor for recharging if needed (the onboard alternators are weak and not meant for charging another vehicle)

Motorisation : Modular 1x1 engine, lots of Cylinders, watercooled. Will not overheat under any load.
Speed : 55-60 Knots max speed
Range : approx 80 Km at full throttle ( about 50 minutes runtime) Untested at lower settings.

Onboard Equipement :
2x hoses
1x electric cable
6x medkit
1x defibrilator
1x handheld beacon locator
2x fire extinguishers
1x welding torch
2x flares
1x oxygen mask
1x night vision binoculars

Features :
-seating for 12 + pilot
-Pitch trimming for optimal speed or wave handling
-light roll auto-compensation
-Deck hose anchor with seawater pump for handheld fire fighting. Note that the pump will deplete the battery relatively fast, dont forget to cut the power once you're done watering.
-Speed limiter for safety.
-waterline lights ( very usefull when you are in the water at night to get your bearings (i often miss a jump and en up in the water))

note :
Max speed is achieved on calm waters with no other settings, pitch trim is meant to deal with harsher seas.
Before engaging Reverse, lower your throttle and release the clutch. Reengage the clutch slowly or you might stall depending on your momentum.

A lot of parameters are tweakable by selecting the microcontrolers, i have been adjusting most of them for quite some time and they should be optimal for this build. I suck at adjusting PID's so this one only has a P (but it does the job nicely ^^) If you can find a sweet setting please let me know in the comments.
I also suck at paintjobs so let me see what you can do!

Do as you wish with this creation, but if you reupload a variation please let me know.

Have Fun !

edited some math and default settings